Detroit DD13 EPA07 (2007-09) Fault Code: SPN 158 FMI 2 (MCM, CPC ) Ignition Switch Not Plausible

NOTE: Please see the step by step troubleshooting procedures for this specific code.

NOTE: If inactive, clear the code, cycle the engine, and see if comes back. If it doesn't problem solved.

Otherwise, POSSIBLE failures are:
1. Measure voltage on the ECM 21-pin connector pin 7 and ground. If less than 11.5 V, repair the wiring to pin 7.
2. If 11.5V or greater, find the Common Powertrain Controller connect #2. Measure the voltage between pin 3 and ground. If less than 11.5V, find source of problem. If greater, repeat procedure.

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 157 FMI 2 (MCM) Erratic Fuel Rail Pressure Sensor Signal

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 157 FMI 1 (MCM) Fault of the Fuel Rail Pressure Sensor, Wiring, or Quantity Control Valve

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 132 FMI 1 (MCM) Air Mass Flow Too Low

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 111 FMI 4 (CPC) Coolant Level Circuit Failed Low

If you want to know other articles similar to Detroit DD13 EPA07 (2007-09) Fault Code: SPN 158 FMI 2 (MCM, CPC ) Ignition Switch Not Plausible you can visit the category DD13 EPA07 (2007-09).

truckshd