Detroit DD16 GHG14 (2014-16) Fault Code: SPN 191 FMI 13 (MCM) J1939 Transmission Output Shaft Speed Signal is Missing or Not Available

NOTE: The Common Powertrain Controller (CPC) may have the same SPN as some Motor Control Module (MCM) faults.

NOTE: Please see the step by step troubleshooting procedures for this specific code.

PROBABLE CAUSES:
1. If battery fault codes present, fix this first.
2. If any programming done recently on the engine, it may be incorrect.
3. Check other computers on truck for failures (ABS, Transmission, cab controller, etc...).

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 191 FMI 13 (CPC) This Diagnostic is Typically the Transmission Output Sped Shaft Signal is Missing

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 191 FMI 9 (CPC) J1939 ETC1 Message is Missing

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 190 FMI 17 (MCM) Engine Over Speed Pre-Warning

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 190 FMI 16 (MCM) Engine Over Speed While Stationary

If you want to know other articles similar to Detroit DD16 GHG14 (2014-16) Fault Code: SPN 191 FMI 13 (MCM) J1939 Transmission Output Shaft Speed Signal is Missing or Not Available you can visit the category DD16 GHG14 (2014-16).

truckshd