Volvo All Engines (2013 Emissions) Fault Code: P113F12 PID: EMS Buffered Idle Validation Switch Wire - VECU Side

Volvo All Engines (2013 Emissions) Fault Code: P113F12 PID: EMS Buffered Idle Validation Switch Wire - VECU Side

The Idle Validation Switch is open at the idle position and transmits no voltage to the (VECU) Vehicle Electronic Control Unit. At approximately 1-13% pedal position the Idle Validation Switch closes and completes the circuit to the (VECU) Vehicle Electronic Control Unit.
The (VECU) Vehicle Electronic Control Unit then sends a voltage signal to the Engine Control Module (ECM) indicating accelerator pedal position. If both communication links (J1939, J1587) are faulty the pedal demand functionality enters limp-home. During limp-home the (IVS) Idle Validation Switch is used for ramping requested torque.

Conditions for diagnostic trouble code (DTC):
1) A diagnostic trouble code (DTC) is set if the output signal from the buffered idle validation (IV) switch diverges from the input signal from idle validation (IV) switch 1
2) Accelerator pedal (AP) released
3) The voltage at pin EI:8 is more than 7?V

Probable cause
1) Signal wire
2) Engine control module (ECM)
3) Vehicle Control Unit (VECU)

If you want to know other articles similar to Volvo All Engines (2013 Emissions) Fault Code: P113F12 PID: EMS Buffered Idle Validation Switch Wire - VECU Side you can visit the category All Engines (2013 Emissions).