PACCAR MX (2004 Emissions) Fault Code: U1819 CAN Communication - Message (ETC1) Not Available, Engine Momentary Overspeed Enable from Transmission System

SET CONDITIONS:
This DTC is set when a CAN message is received correctly, but the content (signal value or status) is not available.

DIAGNOSTIC CONDITION:
The diagnostic runs continuously when the ignition is keyed on.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
The DTC changes to inactive after the diagnostic runs and passes.

REPAIR VERIFICATION:
Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
A malfunction in the system from which the message originates

PACCAR MX (2004 Emissions) Fault Code: U1818 CAN Communication - Message (ETC1) Out of Range, Transmission Shift in Process from Transmission System

PACCAR MX (2004 Emissions) Fault Code: U1817 CAN Communication - Message (ETC1) Not Available, Transmission Shift In Process from Transmission System

PACCAR MX (2004 Emissions) Fault Code: U1816 CAN Communication - Message (EBC2) Out of Range, Relative Speed, Front Axle, Right Wheel from Brake System

PACCAR MX (2004 Emissions) Fault Code: U1815 CAN Communication - Message (EBC2) Out of Range, Relative Speed, Front Axle, Left Wheel from Brake System

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: U1819 CAN Communication - Message (ETC1) Not Available, Engine Momentary Overspeed Enable from Transmission System you can visit the category DTC TRUCKS.

truckshd