PACCAR MX (2004 Emissions) Fault Code: U177B Accelerator Pedal 1 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (B41)

PACCAR MX (2004 Emissions) Fault Code: U177B Accelerator Pedal 1 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (B41)

SET CONDITIONS:
This DTC is set when the ECU detects a higher voltage than expected on the signal or control circuit of the ECU.

DIAGNOSTIC CONDITION:
The diagnostic runs continuously when the ignition is keyed on.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
The DTC changes to inactive after the diagnostic runs and passes.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
1. The sensor or actuator signal wiring has a short circuit to supply.
2. A malfunction of the sensor or actuator

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: U177B Accelerator Pedal 1 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (B41) you can visit the category DTC TRUCKS.