PACCAR MX (2004 Emissions) Fault Code: P1866 Exhaust Gas Pressure Before Turbine - Data Valid but Too High

SET CONDITIONS:
The PCI ECU (D420) detects that the pressure before turbine is more than 9 bar.

DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the engine is running.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
This DTC changes to INACTIVE when the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back? (Can be pending, inactive or active)
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
1. Clogging tube of the pressure sensor before turbine
2. Pressure sensor before turbine deviation
3. Malfunction of the VTG turbocharger or turbocharger actuator

PACCAR MX (2004 Emissions) Fault Code: P1863 CAN Communication - Message (PROPB_AST) Out of Range, Maneuvering Mode From Transmission System

PACCAR MX (2004 Emissions) Fault Code: P1751 Malfunction Indicator Lamp (MIL) - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (B23)

PACCAR MX (2004 Emissions) Fault Code: P1727 VTG Turbocharger Control - Data Erratic, Intermittent or Incorrect

PACCAR MX (2004 Emissions) Fault Code: P1726 Exhaust Gas Pressure Before Turbine - Response Too Slow, On Requested Pressure

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P1866 Exhaust Gas Pressure Before Turbine - Data Valid but Too High you can visit the category DTC TRUCKS.

truckshd