PACCAR MX (2004 Emissions) Fault Code: P103C EGR Control - Unable to Reach Target

SET CONDITIONS:
The PCI ECU (D420) detects that the demanded NOx conversion is limited by the EGR system limits for more than 300 seconds.

DIAGNOSTIC CONDITION:
This diagnostic runs:
1. When the engine is running at a steady load and
2. Coolant temperature is above 50°C [122°F]

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back? (Can be pending, inactive or active)
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
1. Leaking EGR system
2. Clogged EGR system
3. Clogged EGR pressure difference sensor venturi
4. NOx before catalyst sensor deviation

ADDITIONAL INFORMATION:
One way in which the engine NOx emission is controlled is by varying the EGR flow toward the inlet manifold of the engine.

PACCAR MX (2004 Emissions) Fault Code: P102F BPV Actuator Temperature - Data Erratic, Intermittent or Incorrect, at Ignition On

PACCAR MX (2004 Emissions) Fault Code: P102C VTG Turbocharger Turbine - Malfunction

PACCAR MX (2004 Emissions) Fault Code: P102B Exhaust Gas Temperature After BPV - Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (C11)

PACCAR MX (2004 Emissions) Fault Code: P102A Exhaust Gas Temperature After BPV - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (C11)

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P103C EGR Control - Unable to Reach Target you can visit the category DTC TRUCKS.

truckshd