Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6342 PID: SPN: 38 FMI: 9 SAE J1939 Multiplexing PGN Timeout Error - Abnormal Update Rate. The ECM expected information from a multiplexed device but did not receive it soon enough or did not receive it at all.
truckshd
16137 articles
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6343 PID: SPN: 38 FMI: 13 SAE J1939 Multiplexing Configuration Error - Out of Calibration. The ECM expected information from a multiplexed device but only received a portion of the necessary information.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6412 PID: SPN: 7315 FMI: 11 Propulsion System Active - Root Cause Not Known. Unexpected data link communications between the ECM and the propulsion system have occurred.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6416 PID: SPN: 3703 FMI: 31 Particulate Trap Active Regeneration Inhibited Due to Inhibit Switch - Condition Exists. Regeneration of the diesel particulate filter has been prevented due to the permit switch being disabled.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6417 PID: SPN: 974 FMI: 19 SAE J1939 Multiplexing Remote Accelerator Pedal or Lever Position Sensor System - Received Network Data In Error. The OEM vehicle electronic control unit (VECU) detected a fault with the remote accelerator.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6432 PID: SPN: 641 FMI: 14 VGT Actuator Controller - Out of Calibration. The VGT actuator has been installed incorrectly.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6595 PID: SPN: 190 FMI: 11 Engine Speed - Root Cause Not Known. The engine control module has detected the primary and backup speed sensor signals have lost synchronization or are connected backwards.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6642 PID: SPN: 5569 FMI: 4 Aftertreatment 1 Diesel Particulate Filter 1 Soot Sensor ECU Internal Temperature 1 Circuit- Voltage Below Normal or Shorted to Low Source. An internal circuit error has been detected by the aftertreatment particulate matter sensor.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6643 PID: SPN: 5569 FMI: 3 Aftertreatment 1 Diesel Particulate Filter 1 Soot Sensor ECU Internal Temperature 1 Circuit- Voltage Above Normal or Shorted to High Source. An internal circuit error has been detected by the aftertreatment particulate matter sensor.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6644 PID: SPN: 5569 FMI: 4 Aftertreatment 1 Diesel Particulate Filter 1 Soot Sensor ECU Internal Temperature 1 Circuit- Voltage Below Normal or Shorted to Low Source. An internal circuit error has been detected by the aftertreatment particulate matter sensor.