CAT 3406E (Prefix 1MM or 2WS) Fault Code: 42 PID: SPN: 22 FMI: 13 Engine Speed Signal Calibration Not Performed

The Engine Control Module (ECM) detects the following conditions:

•A timing calibration has never been performed on a new ECM or the timing is off by more than three degrees.

Probable Causes:

1) Speed/timing sensor not calibrated properly (Need CAT software to do this)
2) Speed/timing sensor failure
3) Speed/timing sensor harness failure

If you want to know other articles similar to CAT 3406E (Prefix 1MM or 2WS) Fault Code: 42 PID: SPN: 22 FMI: 13 Engine Speed Signal Calibration Not Performed you can visit the category 3406E (Prefix 1MM or 2WS).