Cummins ISB6.7 CM2150 (2007-09) Fault Code: 245 PID: SID 033 SPN: 647 FMI: 4 Fan Control Circuit - Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the fan control circuit when commanded ON.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 249 PID: 171 SPN: 171 FMI: 3 Ambient Air Temperature Sensor 1 Circuit - Voltage Above Normal or Shorted to High Source. High signal voltage detected at ambient air temperature circuit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 252 PID: 98 SPN: 98 FMI: 2 Engine Oil Level - Data Erratic, Intermittent, or Incorrect. An intermittent signal is being received from the oil level sensor.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 253 PID: 98 SPN: 98 FMI: 1 Engine Oil Level - Data Valid But Below Normal Operational Range - Most Severe Level. Very low oil level has been detected by the oil level sensor.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 256 PID: 171 SPN: 171 FMI: 4 Ambient Air Temperature Sensor 1 Circuit - Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the ambient air temperature circuit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 271 PID: SID 126 SPN: 1347 FMI: 4 Fuel Pump Pressurizing Assembly 1 Circuit - Voltage Below Normal or Shorted to Low Source. Low signal voltage detected at the fuel pump actuator circuit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 272 PID: SID 126 SPN: 1347 FMI: 3 Fuel Pump Pressurizing Assembly 1 Circuit - Voltage Above Normal or Shorted to High Source. High signal voltage or open circuit detected at the fuel pump actuator circuit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 281 PID: SID 126 SPN: 1347 FMI: 7 Fuel Pump Pressurizing Assembly 1 - Mechanical System Not Responding Properly or Out of Adjustment
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 285 PID: SID 231 SPN: 639 FMI: 9 SAE J1939 Multiplexing PGN Timeout Error - Abnormal Update Rate. The ECM expected information from a multiplexed device but did not receive it soon enough or did not receive it at all.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 286 PID: SID 231 SPN: 639 FMI: 13 SAE J1939 Multiplexing Configuration Error - Out of Calibration. The ECM expected information from a multiplexed device but only received a portion of the necessary information.