Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2777 PID: 390 SPN: 3703 FMI: 11 Particulate Trap Active Regeneration Inhibited Due to Permit Switch - Condition Exists. Regeneration of the diesel particulate filter has been prevented due to the permit switch being disabled.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2778 PID: 289 SPN: 3481 FMI: 0 Aftertreatment Fuel Rate - Data Valid but Above Normal Operational Range - Moderately Severe Level. The lubricating engine oil needs to be changed due to possible fuel dilution.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2813 PID: 146 SPN: 2791 FMI: 14 EGR Valve Control - Special Instructions. The EGR valve has been closed during regeneration of the aftertreatment diesel particulate filter.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2961 PID: 412 SPN: 412 FMI: 0 Exhaust Gas Recirculation Temperature - Data Valid But Above Normal Operational Range - Least Severe Level. EGR temperature has exceeded the engine protection limit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2962 PID: 412 SPN: 412 FMI: 0 Exhaust Gas Recirculation Temperature - Data Valid But Above Normal Operational Range - Moderately Severe Level. EGR temperature has exceeded the engine protection limit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2963 PID: 110 SPN: 110 FMI: 0 Engine Coolant Temperature - Data Valid But Above Normal Operational Range - Least Severe Level. Engine coolant temperature is above the engine coolant temperature engine protection warning limit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2964 PID: 105 SPN: 105 FMI: 0 Intake Manifold 1 Temperature - Data Valid but Above Normal Operational Range - Least Severe Level. Intake manifold air temperature signal indicates intake manifold air temperature is above engine protection warning limit.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 2973 PID: 102 SPN: 102 FMI: 2 Intake Manifold 1 Pressure - Data Erratic, Intermittent, or Incorrect. The ECM has detected an intake manifold pressure signal that is too high or low for present engine operating conditions.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 3616 PID: SPN: 2633 FMI: VGT Actuator Position - Special Instructions.
Cummins ISB6.7 CM2150 (2007-09) Fault Code: 111 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Critical Internal Failure - Bad Intelligent Device or Component. Error internal to the electronic control module (ECM) related to memory hardware failures or internal ECM voltage supply circuits.