Cummins ISM CM875 (2003-06) Fault Code: 338 PID: S087 SPN: 1267 FMI: 3/3 Idle Shutdown Vehicle Accessories Relay Driver Circuit - Voltage Above Normal, or Shorted to High Source. Open circuit or short to voltage source detected at the idle shutdown vehicle accessory/ignition bus relay circuit.
Cummins ISM CM875 (2003-06) Fault Code: 339 PID: S087 SPN: 1267 FMI: 4/4 Idle Shutdown Vehicle Accessories Relay Driver Circuit - Voltage Below Normal, or Shorted to Low Source. Low voltage detected at the idle shutdown vehicle accessory or ignition bus relay circuit when commanded ON.
Cummins ISM CM875 (2003-06) Fault Code: 341 PID: S253 SPN: 630 FMI: 2/2 Engine control module (ECM) data lost.
Cummins ISM CM875 (2003-06) Fault Code: 343 PID: S254 SPN: 629 FMI: 12/12 Electronic Control Module Warning Internal Hardware Failure - Bad Intelligent Device or Component. ECM power supply errors have been detected.
Cummins ISM CM875 (2003-06) Fault Code: 352 PID: S232 SPN: 1079 FMI: 4/4 Sensor Supply 1 Circuit - Voltage Below Normal or Shorted to Low Source. Low voltage detected at sensor supply number 1 circuit.
Cummins ISM CM875 (2003-06) Fault Code: 386 PID: S232 SPN: 1079 FMI: 3/3 Sensor Supply 1 Circuit - Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 1 circuit.
Cummins ISM CM875 (2003-06) Fault Code: 387 PID: S221 SPN: 1043 FMI: 3/3 Accelerator Pedal Position Sensor Supply Voltage Circuit - shorted high. High voltage detected at sensor supply circuit for the accelerator pedal position sensor.
Cummins ISM CM875 (2003-06) Fault Code: 415 PID: P100 SPN: 100 FMI: 1/1 Engine Oil Rifle Pressure - Data Valid But Below Normal Operating Range - Most Severe Level. Oil pressure signal indicates oil pressure is below the engine protection critical limit.
Cummins ISM CM875 (2003-06) Fault Code: 418 PID: P097 SPN: 97 FMI: 0/15 Water-in-Fuel Indicator - Data Valid But Above Normal Operating Range - Least Severe Level. Water has been detected in the fuel filter.
Cummins ISM CM875 (2003-06) Fault Code: 426 PID: S231 SPN: 639 FMI: 2/2 Communication between the electronic control module (ECM) and another device on the SAE J1939 data link has been lost.