Cummins ISC CM2150 (2007-09) Fault Code: 649 PID: SID 115 SPN: 1378 FMI: 11 Engine Oil Change Interval - Condition Exists. Change engine oil and filter.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM.

This fault code will only become active if the Maintenance Monitor is enabled in INSITE electronic service tool. Make sure that the oil and filter are changed before clearing the fault.

Possible repairs:

1)Change the engine lubricating oil and filter.

Cummins ISC CM2150 (2007-09) Fault Code: 599 PID: SID 025 SPN: 640 FMI: 14 Auxiliary Commanded Dual Output Shutdown - Special Instructions. The engine protection limit has been exceeded for the dual outputs calibrated limits.

Cummins ISC CM2150 (2007-09) Fault Code: 598 PID: 167 SPN: 167 FMI: 1 Electrical Charging System Voltage - Data Valid But Below Normal Operating Range - Most Severe Level. Very low battery voltage detected by the battery voltage monitor feature.

Cummins ISC CM2150 (2007-09) Fault Code: 597 PID: 167 SPN: 167 FMI: 1 Electrical Charging System Voltage - Data Valid But Below Normal Operating Range - Moderately Severe Level. Low battery voltage detected by the battery voltage monitor feature.

Cummins ISC CM2150 (2007-09) Fault Code: 596 PID: 167 SPN: 167 FMI: 0 Electrical Charging System Voltage - Data Valid But Above Normal Operating Range - Moderately Severe Level. High battery voltage detected by the battery voltage monitor feature.

If you want to know other articles similar to Cummins ISC CM2150 (2007-09) Fault Code: 649 PID: SID 115 SPN: 1378 FMI: 11 Engine Oil Change Interval - Condition Exists. Change engine oil and filter. you can visit the category Cumminz.

truckshd