Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3696 FMI 13 (CPC) Diesel Particulate Filter Regen Force MUX Switch Message Contains SNV Indicator

DESCRIPTION:
Signal not available on the CPC DPF switch source address.

MONITORED PARAMETER:
CM1 DPF source add SAE J1939.

TYPICAL ENABLING CONDITIONS:
1. Key on
2. Engine off

EXECUTION FREQUENCY:
Continuous when enabling conditions met.

ENGINE REACTION:
None

VERIFICATION:
Cycle the key to power down, then cycle the key back on.

NOTE: Verify CPC group PGR001 parameter CM1 source add SAE J1939 is set to 49. If set properly, check other computers on the truck for faults.

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3695 FMI 19 (CPC) Diesel Particulate Filter Regeneration Inhibit Switch or Force Switch Message Contains a Data Error Indicator.

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3695 FMI 14 (CPC) Diesel Particulate Filter Regeneration Inhibit Switch or Force Switch Message Not Received This Ignition Cycle

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3695 FMI 13 (CPC) Diesel Particulate Filter Regeneration Inhibit Switch or Force Switch Message Contains Signal Not Valid Indicator

Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3695 FMI 9 (CPC) Diesel Particulate Filter Regeneration Inhibit Switch or Force Switch Message Stopped Arriving

If you want to know other articles similar to Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3696 FMI 13 (CPC) Diesel Particulate Filter Regen Force MUX Switch Message Contains SNV Indicator you can visit the category DD13 EPA07 (2007-09).

truckshd