Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1639 FMI 2 (MCM) Fan Speed Error

DESCRIPTION:
This code sets when a fan speed deviation is detected.

MONITORED PARAMETER:
Fan speed sensor.

TYPICAL ENABLING CONDITIONS:
Always enabled

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Always enabled

TYPICAL DURATION:
Two seconds

DASH LAMPS:
CEL

ENGINE REACTION:
None

VERIFICATION:
Engine running with fan engaged.

NOTE: If 1071-5 or 647-5 active, repair the wiring between pin 91 (from the 120 pin ECM connector) and the fan and the jake brake solenoids.

PROBABLE CAUSES:
1. Coolant loss.
2. Thermostat failure.
3. Blockage in radiator and charge air cooler.
4. Fan belt condition.
5. Proper location of fan shroud.
6. Proper radiator hose condition.
7. Fan failure.
8. Short between fan speed sensor and ECM.
9. Fan drive failure.

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1636 FMI 20 (MCM) Intake Manifold Temperature Drift (Low Box)

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1636 FMI 4 (MCM) Intake Manifold Temperature Circuit Failed Low

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1636 FMI 3 (MCM) Intake Manifold Temperature Circuit Failed High

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1636 FMI 2 (MCM) Engine Air Temperature - Plausibility Fault Out of Range (Low Box)

If you want to know other articles similar to Detroit DD15 EPA10 (2010-13) Fault Code: SPN 1639 FMI 2 (MCM) Fan Speed Error you can visit the category DD15 EPA10 (2010-13).

truckshd