Detroit DD15 EPA10 (2010-13) Fault Code: SPN 164 FMI 0 (MCM) Quantity Control Valve High Side Driver Error

DESCRIPTION:
Quantity control valve (high side).

MONITORED PARAMETER:
Quantity control valve (QCV).

TYPICAL ENABLING CONDITIONS:
Always enabled

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Continuous when enabling conditions met.

TYPICAL DURATION:
2 seconds

DASH LAMPS:
1. MIL
2. CEL

ENGINE REACTION:
Derate 25%

VERIFICATION:
Engine idle: 1 minute.

PROBABLE CAUSES:
1. ECM pin 1 shorted to ground.
2. Quantity control valve failure.
3. Quantity control valve harness/connector.

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 158 FMI 7 (ACM) Battery Power is Disconnected Before Aftertreatment Control Module has Completed the Diesel Exhaust Fluid Key Off Purge Cycle

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 158 FMI 2 (MCM, CPC ) Ignition Switch Not Plausible

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 157 FMI 18 (MCM) Fuel Rail Pressure Too High

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 157 FMI 16 (MCM) Fuel Rail Pressure Too Low

If you want to know other articles similar to Detroit DD15 EPA10 (2010-13) Fault Code: SPN 164 FMI 0 (MCM) Quantity Control Valve High Side Driver Error you can visit the category DD15 EPA10 (2010-13).

truckshd