Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3242 FMI 8 (ACM) Diesel Oxidation Catalyst Inlet Temperature - Signal Spike

NOTE: This fault indicates the aftertreatment control module (ACM) has detected no temperature shift on the diesel oxidation catalyst (DOC) inlet temperature sensor . The most likely cause is an intermittent wiring concern (poor terminal fit, corrosion, chaffing etc.)

NOTE: If codes 3242-3 or 3242-4 active, fix those first.

PROBABLE CAUSES:
1. DOC inlet temperature sensor.
2. DOC inlet temperature sensor connector/harness.

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3242 FMI 4 (ACM) Diesel Oxidation Catalyst Inlet Temperature Sensor Failed Low

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3242 FMI 3 (ACM) Diesel Oxidation Catalyst Inlet Temperature Sensor Circuit Failed High

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3236 FMI 13 (ACM) Exhaust Mass Signal Not Available via Controller are Network

Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3226 FMI 21 (ACM) NOx Outlet Sensor Drift High

If you want to know other articles similar to Detroit DD15 EPA10 (2010-13) Fault Code: SPN 3242 FMI 8 (ACM) Diesel Oxidation Catalyst Inlet Temperature - Signal Spike you can visit the category DD15 EPA10 (2010-13).

truckshd