Detroit DD15 EPA10 (2010-13) Fault Code: SPN 625 FMI 14 (CPC) MCM System ID/MCM_C01 Not Received or Stopped Arriving

DESCRIPTION:
MCM message not received or has stopped arriving.

MONITORED PARAMETER:
CAN communication

TYPICAL ENABLING CONDITIONS:
Always enabled

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Always enabled

TYPICAL DURATION:
Two seconds

DASH LAMPS:
1. MIL
2. CEL

ENGINE REACTION:
None

NOTE: If there are any battery related faults, repair those first.

PROBABLE CAUSES:
1. If any engine components have been programmed recently and are inactive, clear then and test drive to see if they return.
2. Turn ignition off for 5 minutes (leave batteries connected) and turn back on to see if they went inactive.
3. Measure resistance across MCM 12-pin connector at pins 13 and 19. If less than 5 ohms, replace the Power Train CAN harness.
4. ACM Failure.
5. CPC Failure.
6. Wiring between the ACM, CPC, and MCM.
7. MCM Failure.

If you want to know other articles similar to Detroit DD15 EPA10 (2010-13) Fault Code: SPN 625 FMI 14 (CPC) MCM System ID/MCM_C01 Not Received or Stopped Arriving you can visit the category DD15 EPA10 (2010-13).