Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 4 (MCM) Intake Throttle Valve Circuit Failed Low

DESCRIPTION:
This fault code sets when there is an open on the intake throttle valve circuit.

MONITORED PARAMETER:
Intake air throttle

TYPICAL ENABLING CONDITIONS:
Key on

MONITOR SEQUENCE:
None

EXECUTION FREQUENCY:
Always enabled

TYPICAL DURATION:
2 seconds

DASH LAMPS:
1. MIL
2. CEL

ENGINE REACTION:
Derate 10%

VERIFICATION:
Engine Idle: One minute.

PROBABLE CAUSES:
1. Air throttle valve harness.
2. ITV harness connector.
3. Intake throttle valve failure.
4. Cold temperatures may falsly cause this code to appear.
5. Intake throttle valve sensor.

Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 3 (MCM) Intake Throttle Valve Circuit Failed High

Cummins ISC CM2150 (2007-09) Fault Code: 111 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Critical Internal Failure - Bad Intelligent Device or Component. Error internal to the electronic control module (ECM) related to memory hardware failures or internal ECM voltage supply circuits.

Cummins ISC CM2150 (2007-09) Fault Code: 3616 PID: SPN: 2633 FMI: VGT Actuator Position - Special Instructions.

Cummins ISC CM2150 (2007-09) Fault Code: 2973 PID: 102 SPN: 102 FMI: 2 Intake Manifold 1 Pressure - Data Erratic, Intermittent, or Incorrect. The ECM has detected an intake manifold pressure signal that is too high or low for present engine operating conditions.

If you want to know other articles similar to Detroit DD16 GHG14 (2014-16) Fault Code: SPN 51 FMI 4 (MCM) Intake Throttle Valve Circuit Failed Low you can visit the category DD16 GHG14 (2014-16).

truckshd