PACCAR MX (2004 Emissions) Fault Code: P0262 Common Rail Pump Unit 1 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A25)

PACCAR MX (2004 Emissions) Fault Code: P0262 Common Rail Pump Unit 1 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A25)

SET CONDITIONS:
This DTC is set when the ECU detects a higher voltage than expected on the signal or control circuit of the ECU.

DIAGNOSTIC CONDITION:
The diagnostic runs continuously when the ignition is keyed on.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
The DTC changes to inactive after the diagnostic runs and passes.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
1. The sensor or actuator signal wiring has a short circuit to supply.
2. A malfunction of the sensor or actuator

ADDITIONAL INFORMATION:
When this DTC is active:
1. The engine torque is reduced.
2. The engine runs in protection mode.
3. The maximum rail pressure is limited to 1300 bar.

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P0262 Common Rail Pump Unit 1 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A25) you can visit the category DTC TRUCKS.