PACCAR MX (2004 Emissions) Fault Code: P104D Exhaust Gas Pressure Before Turbine - Data Valid but Too High

PACCAR MX (2004 Emissions) Fault Code: P104D Exhaust Gas Pressure Before Turbine - Data Valid but Too High

SET CONDITIONS:
The PCI ECU (D420) detects that the measured pressure before turbine is higher than the expected pressure before turbine for more than 50 seconds.

DIAGNOSTIC CONDITION:
This diagnostic runs:
1. When the engine speed is between 1000 and 1700 rpm and
2. When the engine is running at a steady load and
3. When the coolant temperature is above 50°C [122°F] and
4. The engine mode is SCR high efficiency or standard or protection.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back? (Can be pending, inactive or active)
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
1. Clogged EGR system
2. Blocked exhaust system
3. Restricted pressure sensor before turbine tube
4. Pressure sensor before turbine deviation
5. Air leakage between intercooler and inlet manifold

ADDITIONAL INFORMATION:
1. The measured pressure before turbine is compared with an expected pressure before turbine.
2. The pressure before turbine is measured by the pressure sensor before turbine (F826).

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P104D Exhaust Gas Pressure Before Turbine - Data Valid but Too High you can visit the category DTC TRUCKS.