PACCAR MX (2004 Emissions) Fault Code: P1062 Cruise Control Switches - Data Erratic, Intermittent, or Incorrect

SET CONDITIONS:
The PCI ECU (D420) detects that both the cruise control set(+) switch and the res(-) switch are active at the same time.

DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
Mechanical failure or damage to the cruise control switches

PACCAR MX (2004 Emissions) Fault Code: P1058 Inlet Air Pressure in Inlet Manifold - Data Valid but Too Low

PACCAR MX (2004 Emissions) Fault Code: P1057 Exhaust Gas Pressure Before Turbine - Data Valid but Too Low

PACCAR MX (2004 Emissions) Fault Code: P1055 Retarder Switches - Data Erratic, Intermittent, or Incorrect

PACCAR MX (2004 Emissions) Fault Code: P1054 Downhill Speed Control Switches - Data Erratic, Intermittent or Incorrect

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P1062 Cruise Control Switches - Data Erratic, Intermittent, or Incorrect you can visit the category DTC TRUCKS.

truckshd