PACCAR MX (2004 Emissions) Fault Code: P1230 Common Rail Pump Unit 1 - Short Circuit Between ECU (D420) Pin (A25) and Pin (A26)

SET CONDITIONS:
The PCI ECU (D420) detects a short circuit between ECU pin A25 and pin A26.

DIAGNOSTIC CONDITION:
This diagnostic runs continuously when the ignition is on.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
This DTC changes to inactive after the ignition has been switched off for at least 15 seconds and switched on again and the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
Malfunctioning of the common rail pump unit 1 (L092) or wiring

ADDITIONAL INFORMATION:
When this DTC is active:
1. The engine torque is reduced.
2. The engine runs in protection mode.
3. The maximum rail pressure is limited to 1300 bar.

PACCAR MX (2004 Emissions) Fault Code: P1228 Injector Solenoid Valve Cylinder 4, 5, or 6 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A11) or Pin (A3) or Pin (A7)

PACCAR MX (2004 Emissions) Fault Code: P1227 Injector Solenoid Valve Cylinder 4, 5, or 6 - Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (A11) or Pin (A3) or Pin (A7)

PACCAR MX (2004 Emissions) Fault Code: P1226 Injector Solenoid Valve Cylinder 1, 2, 3 - Voltage Too High or Short Circuit to Supply on ECU (D420) Pin (A2) or Pin (A10) or Pin (A6)

PACCAR MX (2004 Emissions) Fault Code: P1225 Injector Solenoid Valve Cylinder 1, 2, 3 - Voltage Too Low or Short Circuit to Ground on ECU (D420) Pin (A2) or Pin (A10) or Pin (A6)

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P1230 Common Rail Pump Unit 1 - Short Circuit Between ECU (D420) Pin (A25) and Pin (A26) you can visit the category DTC TRUCKS.

truckshd