PACCAR MX (2004 Emissions) Fault Code: P1269 Cylinder 3 - Torque Contribution Too High

PACCAR MX (2004 Emissions) Fault Code: P1269 Cylinder 3 - Torque Contribution Too High

SET CONDITIONS:
The PCI ECU (D420) detects that the combustion contribution of cylinder 3 is higher relative to the other cylinders.

DIAGNOSTIC CONDITION:
This diagnostic runs when the engine is running at a steady speed and load, and the vehicle speed is steady.

CORRESPONDING OBD READINESS MONITOR:
Fuel system monitor

RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the following conditions:
- Corresponding readiness monitor displays 'Ready'
- Diagnostic conditions are met
- Set conditions are met
3. Did the DTC come back? (Can be pending, inactive or active)
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
Fault cylinder 3 injector (overfueling)

ADDITIONAL INFORMATION:
The PCI ECU is able to detect and identify several modes of combustion failure based upon analysis of the rotational speed of the engine. The results from the cylinder-to-cylinder engine speed and the measured combustion-induced rotational acceleration are compared against a stored value which is regularly updated when no faults are present. In this way, the cylinder contribution for each cylinder can be determined.

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: P1269 Cylinder 3 - Torque Contribution Too High you can visit the category DTC TRUCKS.