PACCAR MX (2004 Emissions) Fault Code: U1892 CAN - Message (PROPB_SCD_1) Time-Out from Predictive Cruise Control

SET CONDITIONS:
This DTC is set when the repetition rate of the received CAN message is lower than expected or when the message is not received at all.

DIAGNOSTIC CONDITION:
The diagnostic runs continuously when the ignition is keyed on or when the engine is running.

CORRESPONDING OBD READINESS MONITOR:
None

RESET CONDITION:
The DTC changes to inactive after the diagnostic runs and passes.

REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back?
- No, repair successful
- Yes, repair unsuccessful

POSSIBLE CAUSES:
1. Wiring issues (interruption or contact resistance)
2. Defective components
3. Incorrect software configuration

PACCAR MX (2004 Emissions) Fault Code: U1891 CAN Communication - Message (EBC1) Data Not Correct of Available, Anti-Lock Brake System Active from Brake System

PACCAR MX (2004 Emissions) Fault Code: U1890 CAN Communication - Message (EBC1) Out of Range, Anti-Lock Brake System Active from Brake System

PACCAR MX (2004 Emissions) Fault Code: U1880 CAN Communication - Message (VDC2) Out of Range, Longitudinal Acceleration from Brake System

PACCAR MX (2004 Emissions) Fault Code: U1879 CAN Communication - Message (A1SCREGT) Out of Range, Exhaust Gas Temperature before SCR Catalyst from Aftertreatment System

If you want to know other articles similar to PACCAR MX (2004 Emissions) Fault Code: U1892 CAN - Message (PROPB_SCD_1) Time-Out from Predictive Cruise Control you can visit the category DTC TRUCKS.

truckshd