PACCAR PX-6 CM2150 (2007-09) Fault Code: 415 PID: 100 SPN: 100 FMI: 1 Engine Oil Rifle Pressure - Data Valid But Below Normal Operating Range - Most Severe Level. Oil pressure signal indicates oil pressure is below the engine protection critical limit.

Verify the ECM calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM.

This fault code indicated that low engine oil pressure has been detected by the ECM. Troubleshoot the cause of the low engine oil pressure.

Possible repairs:

1)If necessary, calibrate the ECM.

PACCAR PX-6 CM2150 (2007-09) Fault Code: 386 PID: SID 212 SPN: 3509 FMI: 3 Sensor Supply 1 Circuit - Voltage Above Normal or Shorted to High Source. High voltage detected at sensor supply number 1 circuit.

PACCAR PX-6 CM2150 (2007-09) Fault Code: 352 PID: SID 212 SPN: 3509 FMI: 4 Sensor Supply 1 Circuit - Voltage Below Normal or Shorted to Low Source. Low voltage detected at sensor supply number 1 circuit.

PACCAR PX-6 CM2150 (2007-09) Fault Code: 351 PID: SID 251 SPN: 627 FMI: 12 Injector Power Supply - Bad Intelligent Device or Component. The ECM measured injector boost voltage is low.

PACCAR PX-6 CM2150 (2007-09) Fault Code: 343 PID: SID 254 SPN: 629 FMI: 12 Electronic Control Module Warning Internal Hardware Failure - Bad Intelligent Device or Component. ECM power supply errors have been detected.

If you want to know other articles similar to PACCAR PX-6 CM2150 (2007-09) Fault Code: 415 PID: 100 SPN: 100 FMI: 1 Engine Oil Rifle Pressure - Data Valid But Below Normal Operating Range - Most Severe Level. Oil pressure signal indicates oil pressure is below the engine protection critical limit. you can visit the category DTC TRUCKS.

truckshd