Volvo All Engines (2010 Emissions) Fault Code: SPN 5395 FMI 0 PID: Aftertreatment 1 DPF Regeneration too Frequent

The Engine Control Module (ECM) monitors the crankshaft angular acceleration using the flywheel sensor. The ECM monitors the camshaft position sensor to determine the engine?s position. The ECM calculates the average value of crankshaft angular acceleration for all six cylinders and compares the value to each individual cylinder?s angular acceleration. If a cylinder?s acceleration value is outside a specified range the ECM interprets this as a misfiring cylinder. The crankshaft average angular acceleration value is used by the ECM to determine cylinder balancing and idle speed.

Conditions for diagnostic trouble code (DTC):
1) Calculated fuel consumption, Above normal

Observable symptoms
1) High fuel consumption

Probable cause
1) Power Take Off (PTO) installed without updating parameters and/or software
2) Parameter code, unit injector
3) Fuel
4) Injector

If you want to know other articles similar to Volvo All Engines (2010 Emissions) Fault Code: SPN 5395 FMI 0 PID: Aftertreatment 1 DPF Regeneration too Frequent you can visit the category All Engines (2010 Emissions).