Volvo All Engines (2013 Emissions) Fault Code: P113F11 PID: EMS Buffered Idle Validation Switch Wire - VECU Side

Volvo All Engines (2013 Emissions) Fault Code: P113F11 PID: EMS Buffered Idle Validation Switch Wire - VECU Side

The Idle Validation Switch is open at the idle position and transmits no voltage to the (VECU) Vehicle Electronic Control Unit. At approximately 1-13% pedal position the Idle Validation Switch closes and completes the circuit to the (VECU) Vehicle Electronic Control Unit.
The (VECU) Vehicle Electronic Control Unit then sends a voltage signal to the Engine Control Module (ECM) indicating accelerator pedal position. If both communication links (J1939, J1587) are faulty the pedal demand functionality enters limp-home. During limp-home the (IVS) Idle Validation Switch is used for ramping requested torque.

Conditions for diagnostic trouble code (DTC):
1) A diagnostic trouble code (DTC) is set if the output signal from the buffered idle validation (IV) switch diverges from the input signal from idle validation (IV) switch 1
2) Accelerator pedal pressed down more than 15?%
3) The voltage at pin EI:8 is less than 4?V

Probable cause
1) Signal wire
2) Vehicle Control Unit (VECU)
3) Engine control module (ECM)

If you want to know other articles similar to Volvo All Engines (2013 Emissions) Fault Code: P113F11 PID: EMS Buffered Idle Validation Switch Wire - VECU Side you can visit the category All Engines (2013 Emissions).